klipper_canbus
CANboot
Canboot is a bootloader which can be used to flash firmware on your CAN or USB toolhead board without changing your wiring!
This can greatly simplify maintenance, and is seen by many as a great quality of life improvement.
Due to the sheer number of boards CanBoot now supports each with different means of entering boot mode, firmware requirements etc, I’ve decided to break families of boards into seperate files with full instructions for each.
Below you will find a link to each board family.
Before proceeding however it is critical that your CAN network is configured for your printer, failure to setup the network will cause a problem when you try to connect devices :) click here and select your controller for setup instructions!
Toolhead boards
Huvud
SHTXX (v1)
SHT36 (v2)
EBB v1.0 (F072)
EBB v1.1 (G0B1)
EBB v1.2 (G0B1)
TurboCAN
USBtoCANBridge Adapters
MKS Monster8 v2
